Castrol GPS

GUIDE TO INDUSTRIAL PRODUCTS AND SERVICES

Issue link: http://read.dmtmag.com/i/814629

Contents of this Issue

Navigation

Page 326 of 385

Technical Training and Reference Info Lubrication Technical Training 1 800 255 4417 www.castrol.com/GPS March 2017 Hydraulics Hydraulic System Components Valves Valves are used to control the direction, pressure and flowrate of the hydraulic fluid. Some of the most common valve types are: • Directional Control Valves — Check valves — Spool valves — Proportional valves — Servo valves • Pressure Control Valves — Relief valves — Pressure reducing valves — Unloading valves • Flow Control Valves Basic directional valves (Figure 7) use a spool design to direct flow of fluid to the proper location at the proper time. The spool position dictates the fluid flow paths within the valve. Positioning of the spool may be done by hand, as with a lever-type design, or through electrically controlled solenoids on either end of the valve. Center Position – no flow permitted as fluid from the pump (P) is trapped within the spool. Left Position – flow from pump (P) goes to line A while returning fluid from line B flows to tank (T) T A B T P T A B T P Right Position – flow from pump (P) goes to line B while returning fluid from line A flows to tank (T) Figure 7. Basic directional control valve. Allows fluid to flow from pump (P) to either line A or line B while directing return flow back to the tank. Position of the spool dictates direction of the flow paths. T A B T P Servo valves (Figure 8) are unique valves that control the flow of oil based on electrical input signals to produce precise control and movement of the hydraulic actuator. They have the following features: • Tight tolerance (1-4 micron) • High precision and response rate • High cost • Difficult to fix • Very sensitive to contamination • Recommendations for best operation: — Use high quality, zinc-free hydraulic oil (such as Castrol Hyspin ZZ or Tribol HM 943) — Install a pressure line filter with no bypass — Maintain exceptional cleanliness (ISO PC 16/14/11 or better) — Filter, filter and filter the oil! Figure 8. Cut away of a servo valve. Courtesy of Eaton-Vickers. Torque Motor Flapper Arm Courtesy Eaton-Vickers. Relief valves are found in most hydraulic systems and are used to maintain safe working pressure. They are designed to relieve excess pressure by sending fluid back to the reservoir, and are generally installed as close to the pump as possible. They should not open often or be constantly open, as these are signs of problems in the system. R40

Articles in this issue

Links on this page

view archives of Castrol GPS - GUIDE TO INDUSTRIAL PRODUCTS AND SERVICES