Castrol GPS

GUIDE TO INDUSTRIAL PRODUCTS AND SERVICES

Issue link: http://read.dmtmag.com/i/814629

Contents of this Issue

Navigation

Page 351 of 385

Technical Training and Reference Info Lubrication Technical Training 1 800 255 4417 www.castrol.com/GPS March 2017 Greases and Bearings Bearing Lubrication The frequency of re-lubrication is dependent on many variables and should be determined based on the following information: • Original equipment manufacturer (OEM) recommendations • User historical experience • Grease performance level • Temperature • Dirt contamination potential • Water contamination potential • Bearing type, size and speed • Industry calculations (available from major bearing and lube system manufacturers) Figure 23. Single-point lubricators from perma USA (left) and application example on motor bearings (right). Courtesy of perma USA. The key benefits of single-point lubricators include: • Useful where a bearing is difficult to access on a regular basis • Assurance that the bearing is properly lubricated at all times • A dispense rate that is adjustable • Positive pressure to prevent contamination Figure 22. Proper procedure for manually greasing a bearing. New bearings are often hand-packaged prior to installation, but once in operation, a proper re-grease method is important to ensure long-term success of the bearing. Figure 22 details the main steps in manually greasing a bearing. • Drain plug should be removed prior to greasing and left off for at least 30 minutes after start-up to ensure excess grease purging. • Grease fittings should be wiped clean with a lint-free rag to prevent dirt ingress. • Grease flowing out along the shaft indicates a potential problem (e.g., clogged grease passages and/or failed seals). Difficult conditions such as high temperature, high contamination and low quality grease will require much higher re-grease frequency than is required under ideal conditions. Single-Point Lubricators Single-point lubricators are small, self-contained lubricating units designed to provide a slow, continuous volume of grease to a single lube point (Figure 23). They rely on gas pressure or electro-mechanical action to force the grease to the bearing. Newer designs with positive displacement output can generate enough pressure to lubricate multiple lube points through a distribution block and/or be mounted farther away than traditional models. 1) Remove drain plug 4) Grease flowing out seals along shaft is BAD! 2) Wipe off grease fitting 3) Apply prescribed amount of grease with grease gun 5) Leave off 30 minutes after machine start-up to purge How do I grease this bearing? R65

Articles in this issue

Links on this page

view archives of Castrol GPS - GUIDE TO INDUSTRIAL PRODUCTS AND SERVICES