Issue link: http://read.dmtmag.com/i/814629
Technical Training and Reference Info Lubrication Technical Training 1 800 255 4417 www.castrol.com/GPS March 2017 Gears Types of Gears Spur Gears A spur gear is a toothed wheel with teeth that run parallel to the gear shaft or axle. Spur gears are simple to manufacture, limited in their load carrying ability and known for their noisy operation. • An involute gear tooth profile is most commonly used for a spur gear. • Another familiar form of a spur gear is a "spur rack." In this case, the larger gear is laid out flat with the pinion running back and forth; this is often called a "rack and pinion." Helical Helical gears transmit motion between parallel shafts. Similar in design to the spur gear, the teeth of the helical gear are angled to allow several teeth to mesh at the same time. Because the gear teeth engagement is larger, helical gears can carry greater loads. They also tend to be much quieter and smoother in operation than spur gears. Helical gears produce an "end thrust" along the shaft, which will require special bearings to support this thrust load. Double Helical Gears A double helical gear is commonly called a herringbone gear, based on the opposing an- gles of the gear teeth. It can carry heavy loads at high speed. Double helical gears are used to obtain the lower-noise benefits of a helical gear without the disadvantage of thrust loading. Bevel Gears Bevel gears employ two perpendicular and intersecting shafts with meshing teeth cut straight across the face of a cone-shaped gear blank. Bevel gears are commonly used when a 90° change in direction of shaft power is required. Spiral Bevel Gears The teeth of an ordinary bevel gear can be twisted to form a spiral bevel gear. The "spiral" look results from cutting angled teeth into a cone-shaped gear. The spiral shape allows more teeth to be in contact at one time, similar to a helical gear; this in turn provides greater load carrying than is possible with straight bevel gears. The angled teeth allow for a quiet, smooth transfer of power and a strong gear system. Worm Gears Worm gears consist of a screw-like "worm" meshing with a round "wheel" with perpendicular, non-intersecting shafts. Due to the high sliding nature of the worm gear, lubricants of high viscosity and employing special additives are necessary. Worm gears are typically found where great velocity reductions and/or high torque increases are required within a small arrangement. Having only sliding friction and a high degree of tooth contact, worm gears tend to run hotter and are less efficient (because of higher friction losses) than other gear types. Due to their high level of sliding, worm gears generally need compounded gear oil or synthetic oil made for worm gears. To help reduce frictional losses, a steel worm often meshes with a bronze wheel, since the coefficient of friction is low between steel and bronze. Hypoid Gears Another type of gear with non-inter- secting and crossing shafts is the hypoid gear. Hypoid gears are similar to spiral bevel gears, except the teeth are curved and hyperbolic in shape. Hypoid gears have inherently strong teeth, excellent load- carrying ability and near-noiseless operation. They run very smoothly and quietly and have a high sliding contact, similar to that of a worm gear. This high sliding motion requires lubricants with special additives to maintain film strength. Hypoid gears are common in automotive differentials, but are used infrequently in industrial applications. R26

