Castrol GPS

GUIDE TO INDUSTRIAL PRODUCTS AND SERVICES

Issue link: http://read.dmtmag.com/i/814629

Contents of this Issue

Navigation

Page 336 of 385

Technical Training and Reference Info Lubrication Technical Training 1 800 255 4417 www.castrol.com/GPS March 2017 Hydraulics Hydraulic Fluid Sampling and Oil Analysis Regular oil analysis is important not only for understanding the condition of the oil, but also to ensure the health of the hydraulic system. Taking routine, consistent samples allows the data to be analyzed for trends in support of preventive and proactive maintenance programs. Sample location and consistency from sample to sample are critical for obtaining reliable data that can be trended. Sample Location Sampling from an area of moving fluid within the system is best, from either the return line before the filter (BEST) or the pressure line before the filter (SECOND BEST). Taking a sample before the filter allows contaminants and wear materials to be picked up prior to removal by the filter. Sampling from the reservoir can be acceptable if taken consistently from the center of the oil level. Drain port samples should only be used as a last resort and must be well-flushed prior to taking the final sample. For advanced sampling programs, multiple samples may be taken from various areas of critical hydraulic systems to analyze wear modes of individual components or monitor efficiency of filtration (pre- and post-filter samples). Figure 25. Sample locations for hydraulic system. M Pump OK Bad Best 2 nd Best Class Where Sample Representative of . Best Return line before filters All dirt and metal particles picked up from system components 2 nd Best Pressure line before filters Oil conditions being sent to the system OK Reservoir (vampire pump) Bulk oil in the tank (Take near return line if possible before dirt & metal are allowed to settle) Bad Drain port Junk settling at bottom of tank (Allow good amount of oil to flush out before taking sample) Sampling Techniques The process used for taking samples is critical to assure the consistency of data from sample to sample. Key components of proper sampling technique include the following: • Take consistent samples same location, same person • Label sample locations • Take the sample while system is operating or within 30 minutes of shutdown • Flush sample ports they can build up contaminants • Use clean sample bottles • Triple-rinse bottles with the oil when running particle counts small, invisible particulate in the sample bottle can affect results • Do not re-use sample bottles or sampling tubes • Train the person taking the sample it is best to have one person or a small group who are trained in proper sampling techniques • Send samples to the lab promptly samples can deteriorate in storage and old data is much less useful R50

Articles in this issue

Links on this page

view archives of Castrol GPS - GUIDE TO INDUSTRIAL PRODUCTS AND SERVICES